Architectural Lighting Profiles
Extruded profiles for coves, reveals, facades and decorative runs – where the profile is part of the architecture and has to look right as well as perform.
What this application demands from the profile
Architectural lighting is unforgiving because the profile is seen. Surfaces have to be clean, corners and joints have to line up, and colour has to be consistent along a run that may cross several walls.
The sections are also more varied than in commercial lighting: coves, asymmetric wall-wash sections, recessed reveals and custom decorative shapes all appear, and most are one-off designs.
Architectural lighting profiles - what we supply
| Luminaire type | Coves, reveals, wall-wash, facade and decorative runs |
|---|---|
| Profile role | Diffuser, housing, trim, or a decorative visible section |
| Materials | PMMA for clarity and UV stability; PC where impact or heat matters |
| Surface | Clear, matte, frosted, tinted or prismatic |
| Geometry | Asymmetric and custom sections developed to your drawing |
| Colour | Clear, opal, tinted or matched to RAL / Pantone |
| Environment | UV-stabilised grades for daylight-exposed profiles |
Profile requirements
- Custom and asymmetric sections developed from your drawing
- Clean optical surfaces free of flow lines and die marks
- UV-stable material for daylight-exposed runs
- Colour consistency across a project and across reorders
- Corner and connector solutions for architectural layouts
- Protective packing so surfaces arrive unmarked on site
Frequently Asked Questions
Yes. Asymmetric sections are common in architectural work. Send the beam requirement and the section you have in mind and we engineer it for extrusion.
Corner pieces depend on the section. Send the layout and we advise what can be extruded, what needs machining, and what is better handled as a moulded part.
Optical and decorative surfaces are protected with film and packed to keep them clean and unmarked through transport and site handling.
Send us your drawing or sample
Our engineers review geometry, material and tooling feasibility and come back with a profile proposal and quotation.
Or email your drawing to info@leddiffuserfactory.com · WhatsApp +37259205909 · WeChat +861587897761